This is the built-in help made by Microsoft for the command 'Enable-NetAdapterLso', in PowerShell version 4 - as retrieved from
Windows version 'Microsoft Windows 8.1 Enterprise' PowerShell help files on 2016-06-23.
For PowerShell version 3 and up, where you have Update-Help, this command was run just before creating the web pages from the help files.
Enables the large send offload (LSO) properties, such as LSOv4 and LSOv6, of the network adapter.
Enable-NetAdapterLso [-Name] <String[]> [-AsJob] [-CimSession <CimSession[]>] [-IncludeHidden] [-IPv4] [-IPv6] [-NoRestart] [-PassThru] [-ThrottleLimit <Int32>] [-Con
firm] [-WhatIf] [<CommonParameters>]
Enable-NetAdapterLso [-AsJob] [-CimSession <CimSession[]>] [-IPv4] [-IPv6] [-NoRestart] [-PassThru] [-ThrottleLimit <Int32>] -InputObject <CimInstance[]> [-Confirm] [
-WhatIf] [<CommonParameters>]
Enable-NetAdapterLso [-AsJob] [-CimSession <CimSession[]>] [-IncludeHidden] [-IPv4] [-IPv6] [-NoRestart] [-PassThru] [-ThrottleLimit <Int32>] -InterfaceDescription <S
tring[]> [-Confirm] [-WhatIf] [<CommonParameters>]
The Enable-NetAdapterLso cmdlet enables the state of the large send offload (LSO) settings, such as LSOv4 and LSOv6, on the network adapter. If neither LSOv4 or LSOv6
is specified, then both LSOv4 and LSOv6 are enabled. LSO is a technology in which the work of segmenting data into network frames is performed by the network adapter
instead of by the TCP/IP stack. With LSO, TCP/IP sends very large data packets down to the network adapter driver and the network adapter hardware. The network adapt
er separates the data into smaller network-sized frames. This increases the speed of high-end send operations and decreases the processor usage of the computer, becau
se the work is performed on the network adapter. To enable just LSOv4 or LSOv6, run the Set-NetAdapterLso cmdlet.
<
Online Version: http://go.microsoft.com/fwlink/p/?linkid=287386
Disable-NetAdapterLso
Get-NetAdapterLso
Set-NetAdapterLso
<
EXAMPLE 1
PS C:\>Enable-NetAdapterLso –Name *
This example enables LSO for both IPv4 and IPv6 on all visible network adapters and restarts the network adapters.
EXAMPLE 2
PS C:\>Enable-NetAdapterLso –Name * -IPv4 -IPv6
This example enables LSO for both IPv4 and IPv6 on all visible network adapters by explicitly specifying the parameters and then restarts the network adapters.